YOHO OBD Tool Store-Your Auto Diagnostic Tool Cooperator
High quality 1:1 Renault VCI3 V240 with WIFI support for 1994-2025 Renault Diagnostic Tool
1. Original Design 1:1, original driver, support Renault all models from 1994-2025.
4.Support Kline for old cars, support new cars (Request token by yourself).
5. Support new cars programming and special features ( Request token and dongle).
6.Support ECU Programming/Coding.
7.Support Full Systems Diagnosis Function.
8.Testable System: Engine, Automatic Transmission, Air Conditioning System, SRS, ABS, ASR, MPL, GM, Anti-theft System, KEYZESS GO System and OBD-II System, etc.
9.It Has Powerful Functions to Read Fault Codes, Clear Fault Codes, Dynamic Data Flow, Computer Programming Matching, Component Testing, etc.
10. support win 7/win 10
11.Multi-Languages:English, German, Russian, French, Spanish, Italian, Portuguese, Dutch, Danish, Finnish, Norway, Swedish, Romanian
Supported Car Protocol List:
ISO-9141 K-Line
ISO-14230 K-Line
ISO-15765 CAN
ISO-11898-2 DWCAN
ISO-11898-3 DWFTCAN
Software Support Language
German, Brazilian, Danish, Spanish, Finnish, French, Italian, Norway, Dutch, Portuguese, Romania, English, Swedish
Software for Diagnostic of electronic systems for Renault, For Dacia and For Samsung.
Service program for diagnostic and maintenance of vehicles. Allows full diagnostics ECU cars engine injector, automatic transmission, ABS+ESP, airbags, climate control, staff xenon, CECBS, dashboard.
Function
Integrated information system
Block coding and adaptations
Programming of control units
Activation of Executive mechanisms
Display complete information about Renault cars
Automatic diagnostics of car electronic systems
Testing of the AIRBAG module
Conducting OBD tests
Multi Service Function
For Renult can clip comes with many kinds of service functions including: Oil Reset, EPB Reset, SAS Calibration, DPF Regeneration, Headlight, TPMS Reset, ABS Auto Bleed, Battery Registration, Throttle Reset, Injector Coding, Power Balance, Suspension Calibration, Transmission Adaptation etc.
Oil Reset: Perform reset for a new countdown of engine oil life system once changed the oil.
EPB Reset: Reset brake pads to maintain the electronic braking system safely and effectively.
SAS Calibration: Erase the fault steering angle sensor memories and make calibration for the Steering Angle Sensor.
DPF Regeneration: Clear the blockage via the continuous burning of the particulate matter captured in the DPF filter.
Full OBD2 Test Mode
Reading Codes: Present some diagnostic trouble codes after scanning the vehicle.
Resetting Codes: Clear the fault codes after doing the repair according to the prompt of the scanner.
Live Data Stream: Show the information of continuous data stream from a vehicle in live graphic (waveform) display.
I/M Readiness Shows whether the various emissions-related systems on the vehicle are operating properly and are ready for inspection and maintenance testing.
Freeze Frame: Reads and displays live ECU/PCM data stream, plotting functions graphically and stores freeze frame data.
On-Board Monitor Test: Check the certain vehicle conditions which are recorded by the on-board computer at the time the emission-related fault occurs.
O2 Sensor Test: Allows retrieval and viewing of O2 sensor monitor test results for the most recently performed tests from the vehicle’s on-board computer. (Note:If the vehicle uses a controller area network (CAN) protocol to communicate, this function is not supported by vehicle)
On-Board Monitor Test: Retrieves and displays test results for emission-related powertrain components and systems.
Read Vehicle Information:Display the information such as VIN (Vehicle Identification Number), CID (Calibration ID) and CVN (Calibration verification number), etc.
Component Test: Certain vehicle components can be actuated by commands sent from the scanner to test their operability.
Packing List：
xxxxxx
